We have had a few complaints about dagger boards not fitting in their trunks, but we knew that we had designed in plenty of tolerance, right? We figured that it was sloppy epoxy work or wear strips that weren’t glued down tight. Imagine our surprise when the board didn’t fit into the trunk in our new boat!
What is causing this? Well, to start with, the board is binding at the fore & aft edges, where we thought we had enough clearance. Are the new boards longer in the fore & aft dimension? It doesn’t appear so.
The solution to this problem for existing builders will vary depending on whether the trunk and foils have been built already, or one but not the other have been built.
We apologize for difficulties caused by our screw-up. We will ship out replacement trunk logs for anyone that hasn’t built the trunk yet and we will trim a bit from the aft edge (and re-round) any dagger boards shipped for existing boats.
Please keep in touch if you have any similar issues. We could have found and corrected this much sooner had we known that it was a fore & aft clearance issue. We care about this stuff a lot, so if you find a real issue, let us know.
The new PT 11 manuals are ready. Who needs one?
A very short update about gluing the bumper: We now advise not to use Tolulene to prep your bumper for gluing. It appears to be totally unnecessary. Just sand thoroughly and wipe clean before gluing as described in the manual.
Ashlyn & Russell