Following are pictures of the aft bouyancy tanks coming together.
A blind fillet is made while you have access to the inside area of the tank. 
Glue on the tank sides: 
Glue applied on the blind fillet and glue cleats: 
Glue on the lid, held in place with tape and sticks; 
More finished photos will follow in another post. Had a meeting this weekend discussing the sail design with designer Sandy Goodall. Things are moving forward. Cheers…
Foil kit for the PT Eleven (shown finished) These are prototypes of the foils we will be offering in kit form. The foil shape (naca 0012) is NC machined from Okoume plywood in 2 halves. We bond the 2 halves together in a vacuum bag and the builder does the finish work. 
Some photos of taping the chines…
I am a little behind on posting…Sorry about that. Russell has been working on some details and then had to take off for a week.. I will post more soon. The boat is looking beautiful but we are not done yet. The manual is a full time job. We really appreciate our followers and all your patience. Cheers.. PTW
Pre glassing the back seat/ buoyancy tank parts
Filleting gussets….
PT Eleven in progress;
main bulkheads in place,
daggerboard trunk in place,
mast partners in place,
gussets glued in and all of the above ready for filleting.
Aligning main bulkheads with spacers between.
Main bulkheads glued in.
main bulkheads filleted
Fillet stick set now available. Arrives as 4 sticks connected. You separate them and bevel edges to end up with 8 sizes ranging from 1/2inch to 2 inches. 
$10 + postage. See our site for details. We are including a chisel stick in our set since it is essential for clean filleting!
Hull ready for filleting. 
Filleting the inside of the hull. 
After installing the inner stem, which is a machined part, the panel ends are removed.
Shaping the stem…
